CLASSIC ANO-4
CLASSIC АNО-4 diameter 3mm, weight packs 5kg
CLASSIC АNО-4 diameter 3mm, weight packs 5kg
CLASSIC АNО-4 diameter 4mm, weight packs 5kg
CLASSIC АNО-4 diameter 5mm, weight packs 5kg
Price on request
Price on request
Price on request

Type of coating: rutile.
Э46-АNО-4-d-УД
Е432(3)-РЦ11
Certified in UkrSEPRO

ГОСТ 9466-75; Э 46 по ГОСТ 9467;
Е43 2 RС11 по ISO 2560
E42 0 RС11 по EN 499;
E6013 по AWS A5.1
ТUU 054169 23.050-99

The electrodes are used for welding of angle joints, butt-welded joints, lap-welded joints of metal of 3 to 20 mm thickness. Electrodes with a diameter of 3 mm and 4 mm for welding in all positions except vertical "top-down" and a diameter of 5 mm - for the lower, a diameter of 6 mm - horizontal to the vertical plane and the vertical mode "bottom-up". It used for welding of toggling water pipes joints.

The chemical composition of metal:

С CarbonSi SiliconMn ManganeseS SulfurP Phosphorus
≤ 0.110,10-0.350.40-0.65≤ 0.030≤ 0.035

Recommendations:

The working in all positions is possible without change of welding current during the welding mounting. Welding of vertical joints by “top-down” method should be done by a short arc or buttress. A flowing of slag below an arc should not be allowed. This requires elevation angle of electrode to vertical from 40° to 70°. In down position an electrode should be inclined 20° – 40° to welding from vertical.

Welding conditions:

Welding positionsElectrode diameter (mm)
ø3,0ø 4,0ø 5,0ø 6,0
Welding current 
Lower/ceiling100-140/90-110170-210/140-150190-270/150-170270-320/-
Vertical100-120140-170--

The chemical composition of metal:

С CarbonSi SiliconMn ManganeseS SulfurP Phosphorus
≤ 0.10≤ 0.200.55-0.8≤ 0.04≤ 0.045

Mechanical properties of the weld seam metal:

Temporary tensile strength N/mm2Relative elongation, %Impact strength, J / cm2
4501878

Recommendations:

These welding electrodes are recommended for welding by alternating current from the welding machine dummy voltage of at least 50 V and direct current of any polarity. The daily repeated puncture regime at 180 ° C, 40 min. 

Packing data:

Diameter, mmLength, mmweight packs, kg
3.03502,5
5
4.04502,5
5
5.04502,5
5
6.04505

The position of the welding seams
Subscribe to our newsletter
to always be informed about the news of the Plant
Close
Request a price on:
×